Technical data

Safety Instructions and Warranty Terms 16
Manual econ sens+ Version 1.40
Meter menu
Econ sens+ displays the measured values in tabular form in the Meter menu.
This table is shown in Fig. 17.
The following are displayed: the voltages of the phases L1, L2, L3, the corresponding currents, as well
as the active and the reactive power per phase and the “power factor” (for pure sinusoidal alternating
currents, this is synonymous with the familiar cos phi).
You can refresh the display by pressing the F5 key on your keyboard as required or you can activate
the arrow button next to the word “Actual power”. Then the display will be updated every second.
The vector diagram below the table serves to visualize the phase shift between the voltages L1, L2 L3
and the corresponding currents.
*The “Un” specification below the table indicates the so-called neutral conductor voltage (voltage difference between the neutral
conductor and the protective earth). This is needed for the Events menu, which deals with network analysis. This menu is
however disabled in this software version.
Figure 13: econ sens+ table of measured values
*