User manual

3. PRINTER FUNCTIONS
3-7
DPT100-B
P1) as shown:
1st byte
!!
!!
! 2nd byte
!!
!!
! 3rd byte
!!
!!
!
P6 P5 P4 P3 P2 P1 P6 P5 P4 P3 P2 P1 P6 P5 P4 P3 P2 P1
[Default]
[Reference]
[Example] To print a line of dots, transmit:
$11, n x $7F (where n is the number of characters per line),
$0D.
To print an empty line, transmit:
$11, $40, $0D.
)XTS(CSE)XTS(CSE
)XTS(CSE
)XTS(CSE)XTS(CSE
[Name] Enable infrared port
[Format] ASCII ESC (STX)
Hex 1B 02
Decimal 27 2
[Description] Enable infrared port.
[Notes] • if the printer doesn’t receive this command all data sent to
infrared port are ignored.
• After receiving this command the infrared led is always
switched on.
[Default]
[Reference] ESC (ETX)
[Example]
)XTE(CSE)XTE(CSE
)XTE(CSE
)XTE(CSE)XTE(CSE
[Name] Close down the communication with infrared port
[Format] ASCII ESC (ETX)
Hex 1B 03
Decimal 27 3
[Description] Close down the communication with the infrared port .
[Notes] • The command is active only if the infrared communication
channel has been enabled by the ESC STX command.