User manual

1. INSTALLATION AND USE

81-

DPT100-B

(8)

Note

It is not possible to modify the "flow control" parameter if interface is set in infrared

because it is automatically set in XON/XOFF.

(9)

Note

This parameter regulates battery recharge time. If set to Alkaline, battery recharge

is disabled. If another type of battery other than those supplied with the printer is

used, select the closest appropriate charge value from the list.

(10)

Note

This parameter regulates the period of inactivity after which the printer shuts off

automatically to avoid battery discharge.

Each time the key is pressed quickly, the parameter will change and the

current value will be printed out. Once the desired value has been attained,

hold the key down for at least a second to pass to the next parameter, and

so on. Printing out of a new printer set up report indicates that set up is com-

plete.

1.4 HEXADECIMAL DUMP

This function is used to display the characters received from the

communications port; after the reception of each 10 characters from the

communications port, the printer prints out both the hexadecimal code

received as well as the corresponding ASCII code.

Shown below is an example of a Hexadecimal Dump:

48 65 78 61 64 65

Hexade

63 69 6D 61 6C 20 cimal

64 75 6D 70 20 66 dump f

75 6E 63 74 69 6F unctio

6E 20 30 31 32 33 n 0123

34 35 36 37 38 39 456789

61 62 63 64 65 66 abcdef

67 68 69 6A 6B 6C ghijkl

6D 6E 6F 70 71 72 mnopqr

73 74 75 76 77 78 stuvwx

79 7A yz