User manual

1. INSTALLATION AND USE
31-
DPT100-B
1.2 BATTERIES
1.2.1 Recharging batteries
Appearing in the printer set up print out (see sec. 1.3) is the parameter
HEAD VOLT that gives the battery charge level.
To recharge the batteries
(3)
, use the cable packed with the printer and
proceed as follows:
• connect the battery recharger jack to the cable jack (vedi fig. 1.4) and plug
the battery recharger into the electrical mains;
• connect the cable RJ11 connector to the RJ11 connector located under
the printer (see fig. 1.4). For a complete recharge, we recommend that the
batteries be left to charge for two hours;
(3)
NOTE
During the recharge operation it’s not possible turning the printer off.
WARNING
Incorrect battery recharge voltage (different from that given in tab.
1.2) could seriously damage the printer.
Tables 1.1 and 1.2 provide specifications for the battery recharger
NIPNIP
NIP
NIPNIPLANGISLANGIS
LANGIS
LANGISLANGISTUO/NITUO/NI
TUO/NI
TUO/NITUO/NINOITPIRCSEDNOITPIRCSED
NOITPIRCSED
NOITPIRCSEDNOITPIRCSED
11
1
11
CIRV+REWOPegrahceryrettaB
22
2
22
DNGREWOPlangisdnuorG
tnerrucegrahcerxaMtnerrucegrahcerxaM
tnerrucegrahcerxaM
tnerrucegrahcerxaMtnerrucegrahcerxaM
A6.0
egatlovegrahcerxaMegatlovegrahcerxaM
egatlovegrahcerxaM
egatlovegrahcerxaMegatlovegrahcerxaM
V63-V21
(Fig.1.4)
(Tab.1.2)
(Tab.1.1)