User manual

1.5.2 Setting parallel interface
See paragraph 1.4.2.
1.5.3 Setting JP5 and JP6 jumpers
The JP5 and JP6 jumpers on controller board (see Fig.1.9) manages the setting for the signals of pin 12 and 14
of parallel interface connector as indicated:
SIGNAL OF PIN 12 JP5 SIGNAL OF PIN 14 JP6
FEED GND
ACK LED
Refer to Fig.1.9 for the JP5 and JP6 jumpers position.
JP3
JUMPERS
SELECTION
+VIN ON
PIN 3-4 J3
JUMPERS
SELECTION
SIGNAL ON
PIN 12-14
JUMPERS
SELECTION
INTERFACE
JP4
JP5 JP6
FEED
12
ACK
GND
14
LED
JP1
JP2
TTL CENTRONICS
JUMPERS
SELECTION
SIGNAL ON
PIN 12-14
JP5 JP6
FEED
12
ACK
GND
14
LED
(Fig.1.9)
1. INSTALLATION AND USE
User Manual PLUS II 1-9