User manual

1
1.4 CONNECTIONS OF PLUSII-C AND PLUSII-P
1.4.1 Power supply
The printer is equipped with a 4 pin JST male
connector (90°) for the power supply. The signals
on the connector pins are as follows:
Model no. type:
Header: S4B-PH-K-S 90° (JST)
Housing: PHR-4 (JST) or equivalent
PIN SIGNAL DESCRIPTION
1 GND Ground signal
2 GND Ground signal
3 +Vin* Head voltage
4 +Vcc* Logic supply voltage
NOTE
(*) For the electrical specifi cations see Chapter 4.
WARNING
Respect the polarity of the power supply.
(Fig.1.6)
1. INSTALLATION AND USE
1-6 PLUS II User Manual