User manual

1.7 SELF-TEST
Printer operating status is indicated in the confi guration report in which, next to the name of the components
displayed (see fi g.1.12, fi g.1.13 and fi g.1.14), the following information is given:
under PRINTER TYPE is given the printer model.•
under HEAD VOLTAGE is given the voltage of the printing head.•
under HEAD TEMPERATURE is given the temperature of the printing head.•
PRINTER SETUP
HEAD TEMP. [°C] = 32.5
HEAD VOLT [V] = 5,00
Baud Rate ................. : 38400 bps
Data Length............... : 8 bits/chr
Parity ......................... : None
Handshaking ............. : Xon/Xoff
Autofeed .................... : CR Enabled
Columns .................... : 24 col.
Print Mode ................. : Normal
Char Mode................. : Normal
Print Density.............. : 0
[PUSH] key to enter setup
[FAST PUSH] key to exit
PRINTER SETUP
HEAD TEMP. [°C] = 32.5
HEAD VOLT [V] = 5,00
Interface .................... : Centronics
Autofeed .................... : CR Enabled
Columns .................... : 24 col.
Print Mode ................. : Normal
Char Mode................. : Normal
Print Density.............. : 0
[PUSH] key to enter setup
[FAST PUSH] key to exit
RS232 Models Centronics Models
[PUSH] enter setup
[FAST PUSH] skip setup
PRINTER SETUP
PRINTER TYPE = PLUSII-USB
HEAD VOLT. [V] = 06.58
HEAD TEMP. [°C] = 24
Emulation .................. : PLUSII
Baud Rate ................. : 9600 bps
Data Length............... : 8 bits/chr
Parity ......................... : None
Handshaking ............. : Xon/Xoff
Autofeed .................... : CR enabled
Print Mode ................. : Normal
Chars / inch ............... : A=13 B=17 cpi
Notch Alig. ................. : Disabled
Print Density.............. : 0 %
USB Models
(Fig.1.14)
(Fig.1.13)(Fig.1.12)
1. INSTALLATION AND USE
1-12 PLUS II User Manual