User manual

INTRODUCTION
Mini PLUS
3
1
2
it’s equipped with a 203 dpi thermal printing mechanism, using 57,5 mm-wide paper rolls.
It can print 24 or 40 characters per line according to the selection made at the setup stage or through a
software command; label printing is not possible.
PRINTER DESCRIPTION
The printer has an ABS casing (ref.1 of fig. 2) with a front cover (ref. 2 of fig. 2) which opens to allow access to
the paper roll and print head.
• External FEED key (connect to serial connector see the paragraph 2.1). When the FEED key is
pressed, the printer advances the paper.
During power-up, if the FEED key is held down, the printer enters the SETUP routine.
• The external STATUS led (connect to serial connector see the paragraph 2.1) displays printer operating
status and this check is performed “on-line”. Table 1 lists operating statuses and the LED signals
connected to them:
(Fig.2)
(Tab. 1)
sutatsDELnoitpircseD
ffosyawlAfforetnirP
nosyawlAnoretnirP-tluafon
niknilbwolSg egassemtuOrepaP
gniknilbtsaF )rorreegatlovylppus,erutarepmetrevodaeh(rorreelbarevoceR