User manual

WARNING:
In the regulation of mobile sensor it’s
very important to not use too much
force in moving the sensor inside its sli-
ding guide and not use a tool that could
damage the sensor to avoid breaking
(see fi g.1.5). Adjust the sensor using a
screwdriver or a pencil.
Paper with alignment notches may be used; referred to Appendix B on this manual to see the ticket specifi ca-
tions and management of notch alignment. Fig. 1.6 shows an example of paper roll with notch on the heat
sensitive side (printable side), where:
L = represents the paper width used ( 20 ÷ 54 mm);
L
Direction
of paper feed
Thermal
Side
5
Sensor axis
Notch
7
14
Ticket axis
NOTE: If the notch was on the heat sensitive side, the image on the paper (fi g.1.6) would be mir-
rored in regard to the paper axis.
(Fig.1.5)
(Fig.1.6)
1. INSTALLATION AND USE
User Manual KPM150 1-5