User manual

During the setup routine the printer prints out the setup report (see ﬁ g. 1.3), pressing the LINE FEED key

to enter the Setup mode. To modify printer’s parameters follow the instructions printed on the paper for the

FORM FEED key and LINE FEED key functionality.

1.4 HEXADECIMAL DUMP

This function is used to diagnose the characters received through the communication port; the characters are

printed out both as hexadecimal codes and ASCII codes.

Once the self-test routine has ﬁ nished, the printer enters Hexadecimal Dump mode. The printer remains in

standby until a key is pressed or characters are received through the communication port.

For every 7 characters received, the hexadecimal and corresponding ASCII codes are printed out (if the

characters are underlined, the receive buffer is full). Shown below is an example of a Hexadecimal Dump:

48 65 78 61 64 65 63 Hexadec

69 6D 61 6C 20 64 75 imal du

6D 70 20 66 75 6E 63 mp func

74 69 6F 6E 20 30 31 tion 01

32 33 34 35 36 37 38 2345678

61 62 63 64 65 66 67 abcdefg

68 69 6C 6D 6E 6F 70 hilmnop

71 72 73 74 75 76 77 qrstuvw

1.5 PAPER SPECIFICATIONS

The printer prints on ticket width from 20 to 54 mm adjustable by the user; this printer manages both paper

roll, fan-fold and ticket with notch. Place the notch on the heat sensitive side or on the non-heat sensitive

side of the ticket.

The following paragraphs give the speciﬁ cations and dimensions for each ticketconﬁ guration.

1.5.1 Speciﬁ cations for ticket with notch

Printer is provided with 2 sensors for the notch detection as shown in ﬁ g.1.4, where :

1• = mobile notch sensor

2 • = ﬁ xed notch/transparence sensor.

STATUS

NEAR PAPER

END

(Fig.1.4)

1. INSTALLATION AND USE

1-4 KPM150 User Manual