User manual

1.2 SELF-TEST
During power-up, if the LF LINE FEED key is held down, the printer enters the autotest routine and prints out
the Setup report (see fi g.1.3). The printer will remain in standby in Hexadecimal dump mode (see par.1.4)
until another key is pressed or characters are received through the printer communication port.
Printer operating status is indicated in the confi guration print-out in which, next to the name of the compo-
nents displayed (see fi gure 1.3), the following information is given:
under HEAD VOLTAGE is given the voltage of the head.•
Under HEAD TEMPERATURE is given the temperature of the head.•
Under CUT COUNTER is given the number of cuts made.•
Under POWER ON COUNTER is given the number of power-ups made.•
Under PAPER PRINTED is given the number of centimetres of paper printed.•
PRINTER SETTINGS
PRINTER TYPE .............................KPM150
HEAD VOLTAGE [ V] = 24.29
HEAD TEMPERATURE [°C] = 30
CUT COUNTER = 5507
POWER ON COUNTER = 1843
PAPER PRINTED [cm] = 2635130
Printer Emulation.......................: ESC/POS
Baud Rate ................................: 115200 bps
Data Length ..............................: 8 bits/chr
Parity ........................................: None
Handshaking ............................: Hardware
Busy Condition .........................: RxFull
USB Address Number
(1)
............: 7
Print Mode .................................: Normal
Height Mode
(2)
...........................: x 1
Width Mode
(2)
............................: x 1
Justification
(2)
............................: Left
Character set
(2)
.........................: U.S.A.
Panel Buttons
(2)
.........................: Enabled
Paperend Sensor
(2)
...................: Enabled
Autofeed
(3)
.................................: CR disabled
Chars / inch
(3)
............................: A=15 B=20 cpi
Speed / Quality..........................: Normal
Paper Width...............................: 82 mm
Paper Threshold........................: 60%
Notch Position ...........................: Down Mobile
Notch Threshold
(4)
.....................: 1.25V
Notch Distance [mm]
(4)
..............: +19.9
Print Density..............................: 0%
[LF] enter Printer Setup
[FF] skip Setup
(Fig.1.3)
1. INSTALLATION AND USE
1-2 KPM150 User Manual