Specifications

where:
1°byte
0 = 0000 bit7 = 0 bit6 = 0 bit5 = 0 bit4 =0
(notch found) (not virtual paper end) (ticket not present) (RESERVED)
5 = 0101 bit3 = 0 bit2 = 1 bit1 = 0 bit0 =1
(RESERVED) (near paper end) (RESERVED) (Paper not present)
2°byte
0 = 0000 bit7 = 0 bit6 = 0 bit5 = 0 bit4 =0
(RESERVED) (FF key released) (LF key released) (RESERVED)
4 = 0100 bit3 = 0 bit2 = 1 bit1 = 0 bit0 =0
(drag motor off) (spooling) (cover closed) (print head down)
<BA> n
Printers: KPM150
[Name] Change the ticket print intensity
[Format] ASCII <BA n>
[Range]
[Description] Changes the ticket print intensity where n indicates the print mode. The possible values
of n are as follows :
n PRINT MODE
0 Black/white printing at 100% of maximum intensity
8 Black/white printing at 50% of maximum intensity
16 Black/white printing at 25% of maximum intensity
24 Black/white printing at 12% of maximum intensity
32 Black/white printing at 7% of maximum intensity
40 Black/white printing at 5% of maximum intensity
[Notes]
[Default]
[Reference]
[Example]
<BF x1 y1, x2, y2>
Printers: KPM150
[Name] Command to create fi lled Box
[Format] ASCII <BF x1,y1,x2,y2>
[Range]
[Description] Create a fi lled box on the basis of x1, y1, x2, y2 coordinates where :
x1 -> minimum horizontal coordinate
y1 -> minimum vertical coordinate
x2 -> maximum horizontal coordinate
y2 -> maximum vertical coordinate
[Notes] • If the coordinates are reversed, the printer automatically turns the points to create in
any case the box.
• If the x2 is greater than the maximum horizontal width of graphic page, the box is drawn
using the maximum width as last point.
• If the y2 is greater than the maximum length of graphic page defi ned by <LHT...> com-
mand, the box is drawn using the maximum length (defi ned by this command) as last
point.
[Default]
SVELTA Emulation
44 Command Reference