Instruction Manual

Questions? Call us at: 1 [phone] M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
05/2021
Installation Instructions - Page 2.
2
3
Installation Continued:
4. Install the Driving light bar bracket on the tri-
ple tree by reinstalling the OEM headlight
mounting bolt. Refer to Photo 1.
5. Insert the provided nuts into the slots on the
back of the High Power Driving Light bar. In-
stall the High Power Driving light bar onto the
bracket using the provided mounting bolts.
Do not fully tighten, thread until snug. Refer-
ence Photo 2.
6. If using with our LB-HARN-UNV (sold sepa-
rately) installation harness, Connect the High
Power Driving Light Bar wiring harness to the
LB-HARN-UNV harness after it is installed
and skip to Step 7.
7. If hardwiring to the bike, Cut the plug and
play JAE connector from the Driving Light
bar. Strip back the wires and connect the
Red to a switched +12vdc fused power
source. Connect the Black to a negative
ground.
8. Reconnect the battery negative cable. Rein-
stall the seat and battery side cover.
9. Adjust the Driving Light bar and tighten the
screws to secure in place. Reference Photo
3.
10. Test operation of all lighting before riding.