Instruction Manual

Custom Dynamics® High Power Driving Light Bar
Installation Instructions
Questions? Call us at: 1 [phone] M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
05/2021
We thank you for purchasing the Custom Dynamics® High Power
Driving Light. Our products utilize the latest technology and high
quality components to ensure you the most reliable service. We
offer one of the best warranty programs in the industry and we
back our products with excellent customer support, if you have
questions before or during installation of this product please call
Custom Dynamics® at 1(800) 382-1388.
Package Contents:
- High Power Driving Light Bar (1)
- Mounting Bracket (1)
- 4MM Allen Wrench (1)
- M5 x .8 x10 Bolt (2)
- M5 x .8 Nut (2)
Part Numbers:
Fits: 06-17 Harley Davidson Dyna with 49
mm front ends, 00-17 Softail with 41 mm
front ends. Additional fitments when using
LB-HP-BRACKET (Sold Separately) 87-21
Sportster, 99-05 Dyna and 87-95 FXR models
with 39mm narrow glide front ends.
Warning: Disconnect negative battery cable from battery;
refer to owner’s manual. Failure to do so may result in
electrical shock, injury, or fire. Secure negative battery
cable away from positive side of battery and all other posi-
tive voltage sources on vehicle.
Safety First: Always wear appropriate safety gear includ-
ing safety glasses when performing any electrical work. It
is highly recommended that safety glasses be worn
throughout this installation process. Be sure vehicle is on
level surface, secure and cool.
Important: This product is designed and intended for use
as auxiliary lighting only. It is NOT intended to replace any
original equipment lighting installed on the vehicle and
should not be used for that purpose. This product must be
wired so that it does not interfere with any original equip-
ment lighting.
Note: Off-road use only. Always check federal, state, and
local laws before modifying your motorcycle.
ATTENTION
Please read all Information below before Installation
LB-HP-W-2
Installation:
1. Remove the seat and battery side cover. Discon-
nect the negative battery terminal. Refer to your
owner’s manual if unsure of the process.
2. Protect the front fender with a towel or fender
cover to prevent damage to the painted surface
during installation.
3. Locate the headlight mounting bolt underneath
the bottom triple tree. Loosen the bolt and re-
move.
1