SDS

Conforms to OSHA HazCom 2012 Standard and WHMIS
SAFETY DATA SHEET
Page 6 of 12
TileLab® Sulfamic Acid Cleaner
8.3a. Personal Protective Equipment:
i. Eye/Face Protection: Wear approved eye protection [properly fitted dust- or splash-proof
chemical safety goggles/face (face shield)]
ii. Skin Protection:
1. Hand Protection: Wear impervious gloves, such as nitrile.
2. Body Protection: Wear suitable protective clothing
iii. Respiratory Protection: A NIOSH approved dust mask or filtering face piece is
recommended in poorly ventilated areas or when permissible exposure limits may be
exceeded. Respirators should be selected by and used under the direction of a trained
health and safety professional following requirements found in OSHA’s respirator standard
(29 CFR 1910.134) and ANSI’s standard for respiratory protection (Z88.2).
iv. General Health and Safety Measures: Handle according to established industrial hygiene
and safety practices.
Section 9: PHYSICAL AND CHEMICAL PROPERTIES
Appearance (physical state, color, etc.):
Solid Crystal
Odor:
Characteristic
Odor Threshold:
Not available
pH:
~ 1 – 1.2
Melting point/Freezing point:
215 - 225°C (419-437°F)
Initial boiling point and boiling range:
Not available
Flash point:
Not available
Evaporation rate (Water=1):
Not available
Flammability:
Not flammable
Upper Flammability/Explosive Limit:
Not available
Lower Flammability/Explosive Limit:
Not available
Vapor Pressure
0.008 hPa (0.006 mmHg) at 20°C (68°F)
Vapor Density:
2.151 g/cm3 at 25°C (77°F)
Relative Density:
1.25 – 1.29 g/cc
Solubility in Water:
21.3g in 100ml of water at 20°C
Partition coefficient: n-octanol/water:
Not available
Auto-ignition temperature:
Not available
Decomposition Temperature:
209°C
Viscosity (cps):
Not available
VOC Content:
0 g/L (0%)