TDS

ManualsBrandsCustom Building Products ManualsFlooringSureBond White 40 lb. Unsanded Thin-Set Mortar

SureBond Unsanded Thin-Set Mortar / TDS-195

Application of Product

Installation must conform to ANSI A108.1A. Use a properly-sized notch

trowel to ensure proper coverage under tiles. Using the flat side of the

trowel, apply a skim coat of mortar to the surface. With the notch side

ofthetrowelheldata45°angle,applyadditionalmortartothe

surface, combing in one direction. Press the tile firmly into place in a

perpendicular motion across ridges, moving back and forth. The

perpendicular motion flattens ridges and closes valleys, allowing

maximum coverage. Adjust the tile promptly and beat it in with a

beating block and rubber mallet. Periodically pull up a tile and check

the back to ensure proper adhesive coverage. If the material has

skinned over (not sticky to the touch), recomb with the notch trowel; if

too dry, remove and replace the dry material with fresh material. Thin-

set mortar should not be used to fill low spots in the flooring. For large

format tile and uneven flooring, use mortars designed for medium bed

applications. Mortar thickness should be less than 1/16" thick.

Curing of Product

Curing time is affected by ambient and surface temperatures and

humidity. Use the following as a guideline. Allow 24 hours before

grouting and light traffic, and 7-10 days before heavy or vehicular

traffic. Before exposure to heavy or vehicular traffic, assure assembly

israted“HeavyorExtraHeavy”perTCNAServiceRequirements.As

necessary, use plywood or other load distributing protection when

moving heavy equipment across tiled assembly.

Cleaning of equipment

Clean with water before the material dries.

Storage

Store in a cool, dry area.

Health Precautions

This product contains Portland cement and free silica. Avoid eye

contact or prolonged contact with skin. Wash thoroughly after

handling. If eye contact occurs, flush with water for 15 minutes and

consult a physician. Do not breathe dust; wear a NIOSH approved

respirator.

Conformance to Building Codes

Installation must comply with the requirements of all applicable local,

state and federal code jurisdictions.

6 Availability & Cost

Item Code Size Color Package

SBW40* 40 lb (18.2 kg) White Bag

7 Product Warranty

Obtain the applicable LIMITED PRODUCT WARRANTY at

www.custombuildingproducts.com/product-warranty or send a written

request to Custom Building Products, Inc., Five Concourse Parkway,

Atlanta, GA 30328, USA. Manufactured under the authority of Custom

8 Product Maintenance

Properly installed product requires no special maintenance.

9 Technical Services Information

For technical assistance, contact Custom technical services at 800-282-

8786 or visit custombuildingproducts.com.

10 Filing System

Additional product information is available from the manufacturer upon

request.

Expected Wear

Properly installed tile will last for more than 60 years.