SDS

Conforms to OSHA HazCom 2012 Standard and WHMIS 2015
SAFETY DATA SHEET
Page 5 of 11
Polyblend® Plus Non-Sanded Grout
General Hygiene Advice:
Use good industrial hygiene practices and wear recommended
personal protection. Launder contaminated clothing before reuse.
Wash hands before eating, drinking, or smoking.
7.2 CONDITIONS FOR SAFE STORAGE, INCLUDING ANY INCOMPATIBILITIES
Storage:
Keep out of the reach of children. Keep container tightly closed.
Store at room temperature and keep containers closed when not
in use. Keep dry until use.
Section 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 CONTROL PARAMETER
Exposure Guidelines:
Occupational Exposure Limits
Chemical Name
OSHA-PEL
ACGIH-TLV
Calcium Carbonate
5 mg/m
3
(Resp.)
15 mg/m³ (Total)
5 mg/m
3
(Resp.)
Portland Cement
5 mg/m
3
(Resp.)
15 mg/m
3
(Total)
10 mg/m
3
(Resp.)
Titanium Dioxide
5 mg/m
3
(Resp.)
15 mg/m
3
(Total)
6 mg/m
3
Crystalline Silica, Quartz
0.05 mg/m
3
0.025 mg/m
3
(Resp.)
8.2 EXPOSURE CONTROLS
Engineering Controls:
Use ventilation adequate to keep exposures (airborne levels
of dust, fume, vapor, etc.) below recommended exposure
limits.
8.3 INDIVIDUAL PROTECTION MEASURES
8.3a. Personal Protective Equipment:
i. Eye/Face Protection: Wear approved eye/face protection [properly fitted dust- or splash-
proof chemical safety goggles/face (face shield)]
ii.Skin Protection:
1. Hand Protection: Wear impervious gloves, such as nitrile.
2. Body Protection: Wear suitable protective clothing
iii. Respiratory Protection: A NIOSH approved respirator or filtering face piece, such as N95,
is recommended in poorly ventilated areas or when permissible exposure limits may be
exceeded. Respirators should be selected by and used under the direction of a trained
health and safety professional following requirements found in OSHA’s respirator standard
(29 CFR 1910.134) and ANSI’s standard for respiratory protection (Z88.2).
iv. General Health and Safety Measures: Handle according to established industrial hygiene
and safety practices.