Troubleshooting Guide

TB35
EQUIPMENT REQUIREMENTS
Speeflo PowerTwin 5500DI Direct Immersion Airless Spray Pump
or equal.
w 2.0 GPM with 5.5 HP Honda gas engine or equal.
w 1.25 GPM EXL-DC 115v Electric Motor or equal.
w Titan Tool L70 In-Line Spray Gun w/3 foot extruded extension
and swivel head with appropriate housing for SC-5 reversible
spray tip.
w Course (green) filter in the spray gun.
w Titan Tool SC-5 Reversible Tip (.025-.029 for floor application).
w Minimum 50’ and maximum 100’ of 3/8” Airless Hose.
APPLICATION
Follow all surface preparation instructions on Data Sheets.
Pump pressure: 1900psi to 2300psi depending on tip size
and length of hose.
Tip size: .025 to .029 (425, 427, or 429)
Reduction: None
It is recommended to stir material just prior to use.
To achieve the required film, the coating must be free from
pinholes and air bubbles; air bubbles will cause pinholes.
Apply coating in even passes to achieve 45 mils wet thickness.
Do not backroll coating.
Allow drying for a minimum of 24 hours prior to installation of tile,
stone or terrazzo.
SAFETY INFORMATION
Follow all health and safety precautions when applying
by spray. A 3M dual cartridge respirator and safety glasses
are recommended. See Technical Data Sheet and MSDS for
complete information.
RELATED PRODUCTS
RedGard
®
Waterproofing and Crack Prevention Membrane
REDGARD
®
WATERPROOFING AND CRACK PREVENTION
MEMBRANE SPRAY APPLICATION SPECIFICATIONS
Technical Services 800-282-8786
custombuildingproducts.com
Technical Bulletin
The information in this bulletin is presented in good faith, but no warranty,
express or implied, is given nor is freedom from any patent in as much as
any assistance furnished by CUSTOM
®
with reference to the safe use and
disposal of its products provided without charge. Custom
®
Building Products
assumes no obligation or liability therefore, except to the extent that any such
assistance shall be given in good faith.