Specifications

5 - 11
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5
Tire Inspection
Tire condition should be inspected per the Periodic Service Schedule (Ref. Fig 1 on page 49). Inflation pressures
should be checked when the tires are cool. Be sure to install the valve dust cap after checking or inflating.
Rear Axle
The only maintenance required for the first five years is the periodic inspection of the rear axle for lubricant leakage.
Unless leakage is evident, the lubricant need only be replaced after five years. Refer to the Service and Repair Man-
ual for the fluid replacement procedure.
Brake Master Cylinder
Fluid level in the Brake Master Cylinder should be checked per the Periodic Service Schedule. Brake fluid level must
be maintained between the MIN and MAX indicators on the master cylinder body. Make sure that the area is clean
and free of dirt before removing cap from the master cylinder to add fluid.
Error and Warning Codes
Error and Warning Codes will display in the odometer window as a four or five digit number to indicate a potential
problem with the vehicle. If an error or warning code is displayed contact your E-Z-GO service representative.
Hardware
Periodically, the vehicle should be inspected for loose fasteners. Use care when tightening fasteners. Refer to the
Technician’s Repair and Service Manual for specific torque values.
Generally, three classes of standard hardware and two classes of metric hardware are used in the vehicle.
Grade 5 hardware can be identified by the three marks on the hexagonal head and grade 8 hardware is identified by
six marks on the head. Metric hardware is marked on the head with 8.8 or 10.9. Unmarked hardware is Grade 2.
CODE DESCRIPTION CODES DESCRIPTION
1000
Parking Brake Pad Wear Warning
12818
Battery Voltage High
1001
Power Reduction to Motor
12833
Battery Voltage Low
1002
Motor Speed Sensor
20753
15V Supply Low Voltage
1003
Controller Default Parameter
20755
Sensor Power Error
1004
State of Charger Meter Calibration
21008
Current Sensor Error
1005
Controller Temperature Low
21520
Electrical Short Detected
1006
Charger Connected
16912
Motor Temperature High
1007
Throttle Switch Closed at Start Up
17912
Controller Temperature High
1008
Reverse Alarm Test Failed
20755
Sensor Power Error
8976
Controller AC Over Current
21008
Current Sensor Error
9024
Controller AC Short Circuit
21520
Electrical Short Detected
12576
Controller Charging Time-out
25108
Parking Brake Sensor Error