Instruction Manual
LS (Left Side)
RS (Right Side)
NOTE: There is a Left and Right Door Panel, unless otherwise specified.
For adjustments, see page 6 & 7
Do not disassemble the PVC panel from the bracket or remove
the hinge pin from the mounting plate.
#1. INSIDE SURFACE MOUNTING
Finally, put each unit in place and screw down
tightly to the interior wall using the supplied
1
/4'' x 1
1
/2'' screws and washers. (
See Fig. 2)
Fig. 2
–3 –
6 Mounting
Screws & Washers
Jamb
Wall Mounting
Plate
Header
Fig. 1
CAUTION: Make sure that the door jamb is strong enough to support the weight
and force of the door. If questionable, check with cooler/ freezer manufacturer.
View
from Inside
Cooler/Freezer
Place the right bracket mounting plate with the PVC panel
attached, against the inside right corner of the doorway opening.
Mark the 6 holes. (See Fig. 1)
IMPORTANT: The panel must be able to move
freely beneath the door header and there
should be no gap between the door panel and
the header. Remove the unit and drill the
holes. NOTE: A
5
/ 32'' drill bit should be used.
NOTE: There should be
no gap between the door
panel and the header.
If the panels are not aligning at the center overlap, a simple
adjustment can be made.
FINAL ADJUSTMENTS
–6 –
Loosen (DO NOT REMOVE) the
2 adjusting nuts. By moving the
adjustment plate to one side or
the other, it will force the panel
to move in the opposite direc-
tion. (See Fig. 9) i.e. Move the
plate to the right... the panel will
go left. (See Fig. 10)
Once both panels are exactly
perpendicular to one another,
tighten the adjustment nuts.
Fig. 9
CENTERING
Adjusting
Nut (2)
Adjusting
Nut (1)
Cam
TENSION
Tension
Screw
Lock
Nut
To tighten or loosen the cam spring
tension, first loosen the lock nut at
the bottom of the mounting bracket.
Using an allen wrench, move the
tension screw clockwise to tighten or
counterclockwise to loosen. Once
the proper tension is determined,
tighten the locknut.
If the door panels are not returning to a completely sealed position,
increased tension might be needed.
Adjustment
Plate
Fig. 10
Jamb