Instruction Manual

If the door panels are too
long, the PVC panel will
buckle, allowing cold air to
escape. To remedy this,
the bottom of the panel
should be cut accordingly.
A clearance of 1/8'' is
recommended.
(See Fig 11)
–7 –
Cut accordingly
SEALING
NOTES:
Fig. 11
FINAL ADJUSTMENTS
CHECK YOUR ORDER
Your POLAR-PRO™ Swinging Door was manufactured to your specific cooler
or freezer doorway width and height. Although installation is not complicated,
you will need a helper.
Do not use nails to attach the door panel brackets.
1
/4'' x 1
1
/2'' screws(6) and
washers(6) are included.
2 Door Panels are
attached to the inside
wall surface. For
Mounting Instructions,
see page 3.
2 Door Panels are
attached to the inside
of the doorway opening
using both door jambs.
For Mounting Instructions,
see page 4.
2 Door Panels are
placed on the inside of
the doorway opening,
but use the inside wall
surface for mounting.
For Mounting Instructions,
see page 5.
Thank you for choosing a Curtron quality
product.
The thickness of your door jamb will determine which mounting method to
use. While standing inside the cooler or freezer, measure from the back of
the closed door to the inside wall surface. (See drawings below.)
2
1
/4'' or larger
2
1
/4'' or larger
INSIDE OF COOLER/FREEZER
Recommended for Non-Freezer/Cooler Doors
INSIDE OF COOLER/FREEZER
Front of Door
Front of Door
LS (Left Side)
RS (Right Side)
LS (Left Side)
RS (Right Side)
LS (Left Side)
RS (Right Side)
#2. . . for IN-JAMB MOUNT
#3. . . for WALL/ IN-JAMB MOUNT
#1 . . . for INSIDE SURFACE MOUNT
–2 –