Instruction Manual

ManualsBrandsCurtron ManualsSwinging DoorsCurtron PP-C-080-3490 Polar-Pro Swinging Doors

BRACKET SIZE:

❏ 17'' ❏ 23'' ❏ 29''

COLOR:

❏ Clear

❏ Orange

❏ Gray

❏ Black

❏ White

❏ Blue

OPTIONS:

❏ Vision Strip

❏ Impact Plates

Date of Purchase:

MOUNTING:

❏ #1 Inside Surface

❏ #2 In-Jamb

❏ #3 Wall/In-Jamb

INSTALLATION INSTRUCTIONS

OTHER TMI PRODUCTS

POLAR-PRO

SWINGING DOORS

“Our Input for Your Success”

800•888•9750

TMI, LLC • 5350 Campbells Run Road • Pittsburgh, PA 15205-9738 • 412.787.9750

Fax: 412.787.3665 • Web Site: www.tmi-pvc.com • E-Mail: customer-service@tmi-pvc.com

STRIP DOORS

BULK PVC ROLLS & STRIPS

MEGA-PRO™ SWINGING DOORS

RIP-A-STRIP™

ENCLOSURES

INDUSTRIAL CURTAINS

DOCK ACCESSORIES

AIR DOORS

DESIGN ENGINEERING

TECHNICAL ASSISTANCE

SPECIAL PACKAGING AND

DELIVERY SERVICES

Summary of content (4 pages)

PAGE 1
OTHER TMI PRODUCTS STRIP DOORS BULK PVC ROLLS & STRIPS POLAR-PRO TM SWINGING DOORS INSTALLATION INSTRUCTIONS MEGA-PRO™ SWINGING DOORS RIP-A-STRIP™ ENCLOSURES INDUSTRIAL CURTAINS DOCK ACCESSORIES AIR DOORS DESIGN ENGINEERING “Our Input for Your Success” TECHNICAL ASSISTANCE SPECIAL PACKAGING AND DELIVERY SERVICES BRACKET SIZE: ❏ 17'' ❏ 23'' ❏ 29'' OPTIONS: ❏ Vision Strip ❏ Impact Plates 800• 888• 9750 TMI, LLC • 5350 Campbells Run Road • Pittsburgh, PA 15205-9738 • 412.787.9750 Fax: 412.787.
PAGE 2
FINAL ADJUSTMENTS Thank you for choosing a Curtron quality product. SEALING Your POLAR-PRO™ Swinging Door was manufactured to your specific cooler or freezer doorway width and height. Although installation is not complicated, you will need a helper. Do not use nails to attach the door panel brackets. 1/4'' x 11/ 2'' screws(6) and washers(6) are included. CHECK YOUR ORDER The thickness of your door jamb will determine which mounting method to use.
PAGE 3
#2. IN-JAMB MOUNTING #3. WALL / IN-JAMB MOUNTING CAUTION: Make sure that the door jamb is strong enough to support the weight and force of the door. If questionable, check with cooler/ freezer manufacturer. Do not disassemble the PVC panel from the bracket or remove the hinge pin from the mounting plate. “U” Bracket NOTE: There is a Left and Right Door Panel unless otherwise specified Wall Mounting Plate From inside the cooler/freezer, measure 21/4'' in at the very top of the jamb and place a mark.
PAGE 4
FINAL ADJUSTMENTS #1. INSIDE SURFACE MOUNTING CENTERING CAUTION: Make sure that the door jamb is strong enough to support the weight and force of the door. If questionable, check with cooler/ freezer manufacturer. Do not disassemble the PVC panel from the bracket or remove the hinge pin from the mounting plate. If the panels are not aligning at the center overlap, a simple adjustment can be made. Loosen (DO NOT REMOVE) the 2 adjusting nuts.