, USER S MANUAL Model: LCD2622A Please read this User Manual carefully to ensure the proper use of this product and keep this manual for future reference
Contents Safety and warnings...................................................................................... 2-4 Introduction................................................................................... ..............5 Installation.................................................................................................. 6-9 R emote Control............................................................................ ..............10 Operation................................................
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTION 1.Read these safety instructions. 2.Keep these safety instructions. CAUTION 3.Heed all warnings. RISK OF ELECTRIC SHOCK DO NOT OPEN! 4.Follow all safety instructions. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 5.Do not use this apparatus near water. 6.Clean only with dry cloth. 7.Do not block any ventilation openings.
SAFETY AND WARNINGS High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set. Refer servicing to qualified service personnel. Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it falls. To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture.
SAFETY AND WARNINGS television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected . -Consult the dealer or an experienced radio TV technician for help.
INTRODUCTION Main features Accessories Used as Television, display terminal,PC display AC Power Cord......................... High luminance,wide viewing angle 1 Infrared Remote Control........... 1 3 BTSC User s Manual ........................ 1 4 ATSC digital signals and NTSC analog signals TV. Battery(AAA).......................... 2 HDMI cable is no included.
INSTALLATION Front panel KEYBOARD SOURCE MENU 3 CH+ CH- 4 VOL+ VOL- 2 1 30 1 2 3 4 5 6 7 8 9 1 SOURCE Display the input source menu. 2 MENU Display main MENU. 3 CH+/CHIn TV mode press CH+ or CH- to change the channel up and down. In MENU mode, press CH+ or CH- to select items . In standby mode, press CH+ or CH- to turn on the TV. 4 VOL+/VOLAdjust sound level. In MENU mode, press VOL+ or VOL- to adjust the item that you selected. 30 1: Remote control sensor.
INSTALLATION PC STEPS: Be sure both the TV and computer are set to Power off. 1.Connect VGA and audio cable. 2.Connect the power cord. 3.Power on the TV, switch to VGA mode. 4.Power on the VGA. This sequence is very important. 1 2 PRESET MODE RESOLUTION V.Freq.(Hz) H.Freq.(KHz) 1 720*400 70 31.47 2 640*480 60 31.47 3 640*480 72 37.86 4 640*480 75 37.50 5 800*600 56 35.156 6 800*600 60 37.88 7 800*600 72 48.08 8 800*600 75 46.88 9 1024*768 60 48.
INSTALLATION ANTENNA Note: Aerial connections:IEC(female). Input impendance:75 unbalanced.
INSTALLATION AV EQUIPMENT This TV provides two groups of AV ,two S-Video,one group of YPbPr for convenient connection to VCR,DVD or other video equipment,three group of HDMI for HD signal input Please refer to the owner s manual of the equipment to be connected as well. You can use the input terminals on TV set rear as follows.
REMOTE CONTROL 1: POWER To set the TV standby or on. 2: NUMBER KEY : For direct access to program. 3: MENU To display TV menu or to return to the previous menu. 4: CURSOR To move within the menu. 5: EXIT Used to exit menu. 6: VOL+/To adjust sound level. 7: P .M To switch picture mode. 8: MTS/SAP Switch the sound stereo, SAP and mono. 9: SLEEP Set time to turn off the TV. 10: P.G Setting the Parental Control level control. 11: MUTE To disable or enable the sound.
OPERATION 3.TIMER MENU The third item of the MENU is TIMER MENU. You can adjust time here. Press to select, press to adjust, press MENU to exit. 1. PICTURE MENU The first item of the MENU is PICTURE MENU. You can adjust picture effect here, such as contrast, brightness, etc. Press to select, press to adjust, press MENU to exit. Audio Picture Timer Setup Channel P.
OPERATION 1). Advanced: In PC Mode is available. 5. P.G MENU The fifth item of the MENU is P.G MENU. You can setup Parental Control here. Press to select, press to adjust, press MENU to exit. Parent Control: input the password, it will go into Parental Control menu. Factory default password is 6666. Press button to select Advanced item , Press button, the screen will display as follow: Picture Audio Timer Setup Channel P.
OPERATION 2).MPAA:switch the movie-rating control level: N/A, G, PG, PG-13,R,NC-17,X. 5.2 P . G switch: When the Parental Control switch is ON, the below options can be adjusted. 5.3 US: Press Rating button, the screen will display as follow: G PG Picture Setup Timer Audio Age PG-13 Channel P.G TV R X MPAA NC-17 X Select 1):TV: Press follow: Menu Adjust Description General audiences, All Ages admitted Parental Guidance suggested. Some material may not be Suitable for children.
OPERATION 1). Air/Cable: select air TV signal or cable TV signal. 2). Auto Scan: If it's the first time using the TV, it should scan all the TV channels first, press the button to confirm, you will see below menu : 2).Canada French: switch the French-rating control level: E, G,8ANS+,13 ANS+,16ANS+,18ANS+. Rating Description E Exempt programming G General :All ages and children, contains minimal direct violence, but may be integrated into the plot in a humorous or unrealistic manner .
Trouble shooting Trouble phenomenon Symptom Inspection Check Picture Audio Snow Noise antenna position, direction or connection Ghost Normal audio antenna position, direction or connection Interference Noise electronic equipment,car/ motorcycle,fluorescent light Mute Volume(check if mute is activated or if the audio system connections are not correct) Normal Picture Power cord is not inserted Power switch is not opened Contrast and brightness/volume setup Press standby key on the remote contro
