Service manual

   a.Takeholdofthewhipperchamberwithonehandwhileholdingthewhippermountingplatewiththeother.Turnitclock

   wisetofreeitfromthemountingplate.

   b.Removewhipperchamberfromtheunitandcleanitthoroughly.

  7. Pullthewhipperpropellerfromthemotorshaftandcleanit.

IMPORTANT - When replacing the propeller, make sure the propeller is properly aligned and seated

on the motor shaft. Some propellers may have an indicator; a wide, at surface to lineup with the

at on the shaft (illustration, right).

The newer propellers have an embossed D’, indicating how to position the propeller on the motor shaft.

Failure to push the propeller in all the way will cause the propeller to fuse with the whipper chamber. This

condition will not be covered under warranty.

 8. Cleanthemountingplate.

   a. Cleantheshaftwithaclothandmilddetergentbeforeremovingmountingplate.

   b. Twistthemountingplateclockwiseandpullitfromthemotorshaft.

   c. Cleantheareabehindthemountingplate.

   d. Cleanthewaterinlettting.

   e. Lubricatethecentersealofthemountingplatebeforereinstalling.

 9.Washandrinseallpartsthatwereremovedforcleaning.

 9. Allowpartstodry.Assemblethewhipperassemblyandclosethefrontdoor.

10.Theunitisreadyforuse.

 IMPORTANT-Donotremovepillarstotakeoffmountingplate.

Steps to Programming

Your Curtis Generation 3 cappuccino dispenser is Factory Pre-Set for Optimum Performance.

Entering the Programing Menus

PressandholdSTOP/WASHforaboutten[10]secondsuntildisplayreadsProgram Menus(SeeIllustration).Releasebutton.

Scrollthroughmenuusing→ or ←controlbutton.SelectmenuitemsyouwishtoenterwiththeStop/Washbutton.