Specifications

Routing of Harness and location of each Harness Clip & Wire Tie is very
important so that it will 'ex' properly when the Plow is lowered or raised.
Failure to correctly route and secure Harness may result in severe damage.
D.) Plug the Plow Light Connectors into Harness and secure the connected Plugs to the Lift Frame.
Excess Cord from Lights can be secured with Tie-Wrap where shown. Figure 16.
Section 8. Harness Steps
A.) If Harness and Lift Cylinder Hose are not pre-wrapped together with Hose Wrapping, tie together
using (3) Wire Ties 4" apart starting at the A-Frame exit.
B.) Secure the Harness to the Lift Frame using supplied Harness Clips, Bolts, Nuts and Wire Ties.
C.) Attach Plow Harness to Lift Frame at Tab 'A' using supplied P-Clamp. Route Plow Harness in front
of Lift Frame Up Left tube (Driver’s side) and attach Harness to Tab 'B' using supplied P-Clamp.
Tab 'B' has 3 mounting holes to allow proper Harness reach for different height trucks. If the Plow is
assembled in the bottom set of Side Plate mounting holes, use the bottom hole in Tab 'B'.
See Figures 16 & 17.
21 of 29
Sno-Pro 3000 Assembly Instructions
CAUTION
Connect both Headlights
to Harness then secure
connected Plugs with
Cable-Ties to Lift Frame
Cable-Ties
Cable-Ties Cable-Ties
Tab 'B'
with Clamp
Tab 'A'
with Clamp
Lift Hose
Cable-Tie
Figure 16. Secure Harness to Lift Frame