Specifications

16 of 29
Sno-Pro 3000 Assembly Instructions
Section 5. Lift Frame Side Plate Install (continued)
C.) Install Torsion Spring Bushings (1TBP113) through the Torsion Springs and over the Hinge Pins.
Fasten loosely with (1) 1/2"-13 x 1" Patch Bolt and 1/2" Flat Washer threaded into each Hinge Pin to
secure the assemblies. Do not tighten Bolts at this time. Repeat procedure on opposite side.
D.) Using the A-Frame as a lever, grasp the A-Frame near the Side Plates at the top of the assembly and
pull back, raising the Moldboard to the vertical position.
E.) Secure one end link of the Lift Chain to the middle hole in the Chain Bracket on the A-Frame
using (1) 5/16" Chain Shackle supplied in Plow Hardware Bag. Figure 11 on the next page.
The 3 mounting holes are used to ne-tune the attachment and lifting
performance of the Plow on a specic vehicle. The middle hole is a good
starting point.
F.) Install (1) Blade Marker at each end of Moldboard using hardware supplied with Blade Markers.
Figure 11 on the next page.
NOTE
Figure 9. Secure Angle Cylinder Rams to Trip Frame
3/16" x 2"
Cotter Pin
S
w
i
n
g
A
-
F
r
a
m
e
L
&
R
t
o
i
n
s
e
r
t
P
i
n
s
1" x 4" Clevis Pins