Specifications

Sno-Pro 3000 Assembly Instructions
13 of 29
Figure 4. Mount Eyebolts to Trip Spring Mounting Brackets
Thread Jam Nut halfway &
add Lock Washer before inserting
through Moldboard Bracket
Tighten Jam Nuts on Eyebolts until
correct Spring tension is achieved
B
A
End Cap
End Cap
Figure 5. Install Trip Springs
Section 3. Mount Trip Springs
A.) Mount (4) Trip Springs (1TBP33) to Trip Frame.
See Figure 7 on next page to determine upper or
lower mounting hole usage.
B.) Thread (1) 5/8" Jam Nut half-way onto each
Spring Eyebolt.
C.) Slide (1) 5/8" Lockwasher onto each
Spring Eyebolt (1TBP34) and then insert each
Eyebolt into the Spring Brackets on Moldboard.
Figure 4.
D.) Thread (1) 5/8" Locknut onto each Eyebolt.
E.) Tighten Locknuts to increase tension on
Springs until there is enough space between the
coils to slide a piece of paper. Do not overtighten.
F.) Tighten each 5/8" Jam Nut and Lock Washer
against each Moldboard Spring Bracket to lock
the Eyebolts.
G.) Press t End Caps to Eyebolt ends.