Specifications

11 of 29
Sno-Pro 3000 Assembly Instructions
Section 1. Moldboard Assembly
A.) Lay Moldboard on its face. Place cardboard under the Moldboard top bend to prevent paint damage.
B.) Locate (4) Moldboard Spring Mount Brackets (2 Left, 2 Right). Brackets must be installed with Spring
mounting tab pointing to the outside of the Moldboard, not the center. Install each Bracket as shown using
(3) 3/8"-16 x 1-1/4" Gr.8 Bolts, Flat Washers and Nylock Nuts. Torque to 30 ft/lbs.
Refer to Figure 1 below & Figure 6 on page 14.
Section 2. Mount Trip Frame to Moldboard
A.) Using (4) 1" x 4" Clevis Pins, mount Trip Frame to Moldboard. Figures 2 & 3 on the next page.
Figure 1. Mount L & R Trip Spring Brackets to Moldboard
3/8"-16 x 1-1/4" Bolt
3/8" Nylock Nut
3/8" Flat Washer
Note direction of Hardware when mounting Brackets.
All views in this manual show the Polyethelene Moldboard Plow assembly.
The assembly and mounting of the Steel Moldboard Plow is identical.
NOTE