Specifications

Curtis PMC 1223/33, 1225/35, 1227/37 Manual
48
KEY OFF DECEL
The key off decel function decelerates the vehicle to zero speed per the specified
deceleration delay if the keyswitch is turned off while the vehicle is in motion. If
the key off decel function is disabled, the controller shorts the motor if the
keyswitch is turned off, causing a severely abrupt stop of the vehicle. It is therefore
recommended that the key off decel function be enabled.
OEM specifies ➤ On or Off Default setting ➤ On
POWER SAVER
The power saver function releases the main contactor if the controller does not
receive any throttle commands in a 25-second period; it shuts the controller off
completely if no commands are received in a 25-minute period. This reduces the
residual current draw on the batteries and extends vehicle range. The keyswitch
must be cycled to activate the controller after the power saver has shut it down.
If the power saver function is disabled, the controller will remain on as long as the
keyswitch input is active.
OEM specifies ➤ Enable or Disable Default setting ➤ Enable
MULTIMODE™
A key feature of Curtis PMC MultiMode™ controllers is their capability of being
configured for optimized performance in two distinctly defined modes. However,
should the OEM prefer to offer only a single mode of operation in a given
application, the MultiMode™ feature can be disabled. Additionally, each of the
seven MultiMode™ parameters can be individually defined as MultiMode™ or
single mode.
OEM specifies ➤ On or Off Default setting ➤ On
4 — OEM-SPECIFIED, FACTORY-SET PARAMETERS