Specifications

The programmer handset is a handheld tool that allows the user to program, test, and diagnose the
traction motor controller. See Figure 3. It has been designed for ease of use with eight keys to control
all functions. A MORE INFO key is included to provide more detail on any display item.
The display window contains a four-line LCD display. This display is visible in most lighting conditions.
When the programmer is in the PROGRAM, TEST, or DIAGNOSTICS mode, 4 lines of a menu are
displayed. The item at the top of the display window is the selected item (in the PROGRAM menu, the
selected item will be highlighted with a flashing arrow).
1. 4-LINE LCD DISPLAY WINDOW
2. SELECTS PROGRAM MENU
3. SCROLLS DISPLAY UP AND DOWN
4. SELECTS MORE INFO, SPECIAL PROGRAM, AND DIAGNOSTIC MENUS
5. SELECTS TEST MENU
6. SELECTS DIAGNOSTICS MENU
7. CHANGES VALUE OF SELECTED ITEM
Figure 3. Curtis 1307 Programmer Handset
SCROLL DISPLAY KEYS
To scroll up and down within a menu, use the 2 scroll display arrow keys. The scroll display arrow
keys can be pressed repeatedly or held down. When a key is held down, the scrolling speed increases
the longer the key is held.
To the left of the PROGRAM, TEST, and DIAGNOSTICS menu, a small scroll bar is displayed. The
scroll bar gives a rough indication of the position of the four displayed items within the entire menu.
That is, when the scroll bar is at the top of the window, the top of the menu is displayed. When
scrolling through the menu, the bar will move downward. When the bar is at the bottom, the end of the
menu has been reached.
CHANGE VALUE KEYS
The change value arrow keys increase or decrease the value of the selected menu item. There is an
LED on each arrow key to indicate when the key is active and a change is permissible. When the LED
is off, the limit setting (maximum or minimum) of the function has been reached.
The change value keys may be pressed repeatedly or held in the same manner as the scroll display
keys. The longer the key is held the faster the value changes. This allows rapid changing of any
function value.
MORE INFO KEY
The more info key is used to display additional information about the selected item and to access the
SPECIAL PROGRAM menu and the DIAGNOSTICS HISTORY menu. When the programmer is in any
of the operating modes, the more info key may be pressed to display additional information about the
selected item. Press the more info key again to return to the original list. In the PROGRAM menu, a
bar graph is displayed along with the minimum and maximum values available for the selected item. If
the minimum or maximum value has been programmed, a message replaces the bar graph, and any
dependencies are listed.
Operation
CONNECTING HANDSET TO TRACTION MOTOR CONTROLLER
NOTE: Each time the programmer handset is connected to the controller, it acquires all of the
controller function value settings and stores them in its temporary memory. This allows the user to
revert back to the original settings at any time. The SPECIAL PROGRAM menu selection RESET ALL
SETTINGS is used to revert to the original settings. Any unwanted change made to any of the function
values can be "undone" in this manner, as long as the programmer has not been unplugged or the key
switch has not been turned to the OFF position (power disconnected).
1. Turn the key switch to the OFF position.
2. Disconnect and separate battery connector.
3. Remove drive unit compartment cover.
524164719-2200YRM0928-(07-2010)-US-EN
http://www.yaleaxcessonline.com/lib/service/US/EN/html/2200YRM0928...
6 of 33
4/29/2013 7:30 PM