Specifications

Figure 19. Menu Selection
Programmer Setup Menu
The PROGRAMMER SETUP menu contains several items that can be viewed, setup, or customized to
the user’s preference. See Figure 20.
Figure 20. Menu Selection
Programming the Traction Motor Controller - 1311 Handset
WARNING
NEVER adjust function settings outside the range recommended for the specific truck model.
See Table 1 or Table 3.
Program changes affect lift truck performance and operation. If function settings are changed,
make sure all operators of the lift truck know that the truck has been changed and may
operate differently.
1. Turn the key switch to the OFF position.
2. Disconnect and separate the battery connector.
3. Remove drive unit compartment cover.
WARNING
The capacitor in the traction motor controller can hold an electrical charge after the battery is
disconnected. To prevent electrical shock and injury, discharge the capacitor before inspecting
or repairing any component. Wear safety glasses. Make certain the battery has been
disconnected. Discharge the capacitors using the recommended procedures and never by any
other method.
4. Discharge the capacitors in the traction motor controller by connecting a 200-ohm, 2-watt resistor
across the controller’s B+ and B− terminals using two insulated jumper wires.
5. Connect programmer handset to traction motor controller. The cord of the handset plugs into the J3
connector on the front of the controller.
NOTE: Each time the programmer handset is connected to the controller, it acquires all of the
controller function value settings and stores them in temporary memory. This allows the user to return
to the original settings at any time. Any unwanted change made to any of the function values can be
undone in this manner, as long as the programmer has not been unplugged or the key switch has not
been turned to the OFF position (power disconnected).
6. Reconnect the battery.
7. Turn the key switch to the ON position.
8. Select the PROGRAM menu on the programmer handset.
9. Use the up or down arrows on the menu navigation key to scroll until the desired function is
reached.
10. Press the right arrow on the menu navigation key to enter the function being changed.
WARNING
NEVER adjust function settings outside the range recommended for the specific truck model.
524164719-2200YRM0928-(07-2010)-US-EN
http://www.yaleaxcessonline.com/lib/service/US/EN/html/2200YRM0928...
16 of 33
4/29/2013 7:30 PM