VoomPC-2™ Automotive PC Enclosure Mini-ITX Car PC Enclosure Installation Guide Version 1.
http://www.cartft.com, Cool Embedded PCs Please take a moment and read this manual before you install the VoomPC-2™ in your vehicle. Often times, rushing into unit installation can result in serious damage to your motherboard, power supply and probably your car’s electrical system. The VoomPC-2 has a wire harness that needs to be connected to the car’s electrical system. During installation, always double check the polarity using a voltmeter.
http://www.cartft.com, Cool Embedded PCs 1.0 Introduction Thank you for purchasing the VoomPC-2 mini-ITX vehicle enclosure! The VoomPC-2 was designed to work with a wide variety of main boards such as the VIA mini-ITX boards as well as low power Pentium-M OR Core 2 Duo. Please note that powering full power P4 or AMD systems is not recommended due to excessive heat dissipation. 2.
http://www.cartft.com, Cool Embedded PCs Figure 1.0, bottom mounting plate 3.0 VoomPC-2 installation steps 1) Install the motherboard, Front Audio / USB board and Power Supply on the base plate using M3 screws. (See figure 1.0) 2) Connect the ATX cable harness provided with your power supply to the motherboard. NOTE: Use small tie-wraps on the ATX cable harness in order to improve air flow.
http://www.cartft.com, Cool Embedded PCs 7) Install the HDD and CDROM (optional) into the metal bracket and connect to the motherboard using the IDE cable. 8) Install the motherboard I/O shield at the back of the VoomPC-2 enclosures Figure 1.1, bottom mounting plate 9) Your final assembly should look similar to Figure 1.1. Slide the bottom plate into the extrusion and stop half way into the slide. Connect the power input faston wires to the Power Supply unit.
http://www.cartft.com, Cool Embedded PCs 4.0 Power Connector Wiring Diagram Figure 1.3, power connector diagram Connector type is Molex “mini-fit JR” series, 2 x 4 configuration. Consult www.molex.com for additional information on housings and mating pins (male/female). All “mini-fit JR” parts can be purchased on-line from www.digi-key.com. NOTE: The Black and Green wire harness labeled “not connected” is intended to special projects use.
