Installation Guide

Instruction sheet

Figure 2

Figure 1

Under-bed mount

Safety chain

anchor

60629 gooseneck ball

Truck bed

60691 safety chain loops shown properly installed

Always install both safety chain loops in rear-most under-bed mounts

Periodically check all gooseneck components to ensure that

fasteners are tight and that structural components are sound.

Vehicle performance, such as braking, handling,

acceleration and turning radius, can be drastically

affected by the trailer. Allow additional time and space

for stopping, changing lanes, passing and turning.

Do not tow more than one trailer at a time.

This may cause loss of control.

Severe bumps can damage your towing system.

Avoid or drive slowly over rough terrain.

WARNINGS

OEM PUCK SYSTEM GOOSENECK BALL

AND SAFETY CHAIN ANCHOR KIT

PARTS LIST

Item Qty Description

1 2 Safety chain anchor

2 2 10mm pin

3 2 5mm lynch pin

4 1 Gooseneck ball

5 1 Rubber cover

6 1 Case

INSTALLATION INSTRUCTIONS

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY

PAGE 1 • 60692-INS-RB • 1.800.798.0813 • NEED ASSISTANCE? • CURTMFG.COM

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY OEM PUCK SYSTEM GOOSENECK BALL AND SAFETY CHAIN ANCHOR KIT 6 Instruction sheet 4 5 3 2 1 PARTS LIST 3 Item Qty Description 1 2 Safety chain anchor 2 2 10mm pin 3 2 5mm lynch pin 4 1 Gooseneck ball 5 1 Rubber cover 6 1 Case 2 1 Figure 1 60629 gooseneck ball WARNINGS Periodically check all gooseneck components to ensure that fasteners are tight and that structural components
PAGE 2
60629 OPERATION Step 1 To install the 60629 gooseneck ball, lift the handle from its seat and rotate 90°. Insert the gooseneck ball into the receiver tube in the bed of truck. Rotate the handle to the locked position and flip it down into its seat. See figure 3. Note: If handle does not freely rotate into the locked position, rotate the ball while applying light pressure to the side of the handle. When the handle rotates into the locked position flip it down into the seated position.
PAGE 3
BEFORE TOWING FOR THE FIRST TIME BEFORE TOWING EVERY TIME Verify adequate turning clearance between the truck cab / box corners and trailer(s). Ensure all fasteners are tight and that all structural components are sound. Note: Do not tow trailer with worn or damaged parts. Check truck box clearance. There should be a minimum clearance of 6" between the bottom of the trailer(s) overhang and the top of the box sides. Verify all anchors are properly installed and secured with lynch pins.