Owners manual

Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
FORD F-150
2/18/2016
**DO NOT EXCEED RECOMMENDED VEHICLE TOWING WEIGHT!**
60649 SUBKIT
PAGE 1 OF 4
WARNING!! BRAKE, FUEL, AND ELECTRICAL LINES MAY NEED TO BE LOOSENED OR REPOSITIONED TO PROVIDE CLEARANCE FOR NEW HARDWARE. SOME
MODELS MAY REQUIRE MODIFICATION OR REMOVAL OF HEAT SHIELDS. ON SHORT BED MODELS, CHECK FOR ADEQUATE TURNING CLEARANCE
BETWEEN THE FRONT OF ALL TRAILERS AND THE TRUCK CAB. ON TWO WHEEL DRIVE TRUCKS A CLEARANCE CHECK MUST BE PERFORMED
WHEN TRUCK IS LOADED AND UNLOADED TO VERIFY THE INVERTED BALL WILL NOT INTERFERE WITH THE TOP OF THE DIFFERENTIAL
90
57
45
SUBKIT WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS GOOSENECK HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
FIGURE A
Hardware
DESCRIPTIONPART NUMBERQTYITEM
DRIVER SIDE WELDMENT60649-DSW1A
PASSENGER SIDE WELDMENT60649-PSW1B
1" x 2" FRONT CROSS ARM60649-FCA1C
2.50 x 2.00 x .375" REAR CROSS ARM60649-RCA1D
GOOSENECK GALVANIC ISOLATOR609101
E
PARTS LIST
DESCRIPTIONPART NUMBERQTYITEM
5/8" FISHWIRE5_8 FISHWIRE41
HEX FLANGE NUT5/8-1162
CARRIAGE BOLT5/8-11 x 1 3_4, GR863
HEX BOLT1_2 - 13 x 1 1_2 HEX, GR8104
CONICAL TOOTHED WASHER1/210
5
HEX FLANGE NUTHFN 1213, GR8
46
.250 x 1.25 x 2.50" SQUARE HOLE SPACERCM-SP9
27
.250" SPACER60649-SP
48
- NO DRILLING INTO FRAME
- NO LOWERING EXHAUST
- FISHWIRING REQUIRED
- TRIMMING REQUIRED
←FRONT OF VEHICLE REAR OF VEHICLE→
DESIGNED FOR USE WITH
60607 CENTER SECTION
(NOT INCLUDED IN SUBKIT)
DRIVER SIDE
FRAME RAIL
PASSENGER
SIDE FRAME
RAIL
ACCESS HOLE
(BOTH SIDES)
3
7
5
4
2
2
3
8
1
APPROXIMATE TRIM LINE
1 1/4"
5/8"
4 1/8"
DRIVER SIDE FRAME RAIL
BUMP STOP BRACKET
FLANGE BELOW BED
FLOOR ON DRIVER
SIDE WHEEL WELL
FRONT BED
SUPPORT
C
D
B
A