Owners manual

Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
KEEP IN VEHICLE FOR FUTURE REFERENCE
60630 QUICK GOOSE 2 Page 3 of 6
FIGURE 1
FIGURE 2
BOTTOM VIEW
B
O
L
T
B
O
L
T
Installing U-Bolt Kit
1) After the 60630 is centered and torqued to specifications, from under the bed, using the 60630 as a template,
mark (4) holes within the (4) slots to be drilled for the Safety Chain U-Bolt Kit attachment.
NOTE: BE SURE HOLES ARE MARKED AND DRILLED IN THE LOWER RIB SECTION OF THE TRUCK BED
/ SEE FIGURE 3.
CHOKER
INSERT M6 x 1 x 35mm
HEX BOLTS AS SHOWN
EXTENSION
SPRING
COMPRESSION SPRING
DO NOT OVER TIGHTEN.
SEE STEP 6 / PAGE 1
PULL ROD
RED GRIP
(CM-C630-PRRW)
PULL ROD
BLACK GRIP
(CM-C630-PRL)
LINKAGE
FIGURE 3
UNDER BED OF TRUCK
HIGH RIB
SECTION
LOW RIB
SECTION
HOLE
LOCATION(S)
2) The Safety Chain U-Bolts are 16mm [0.629 in.] diameter, size and drill the holes accordingly.
3) SEE FIGURE 4 FOR CORRECT INSTALLATION OF THE SAFETY CHAIN U-BOLTS AND THEIR
HARDWARE.
FIGURE 4
16mm U-BOLT
16mm ID x 36.4mm OD
FLAT WASHER
U-BOLT SPRING
M16 x 1.25
CENTERLOCK NUT
IMPORTANT:
A MINIMUM OF 3 FULL THREADS OF THE U-BOLT MUST
EXTEND PAST THE M16 x 1.25 CENTERLOCK NUT.
NOTE: ALL M6 x 1 x 35mm BOLTS ARE INSTALLED
FROM THE MIDDLE OF THE UNIT AND POINT OUTWARD.
SHAFT
COLLARS