Owners manual

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
C-625 TOYOTA TUNDRA GOOSENECK HITCH
FIGURE 1
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
SAFETY CHAIN LOOP ASSEMBLYCM-C-60-CLA21
2" x 3" SAFETY CHAIN LOOPCM-C-60-CL11.1
5 LB U-BOLT SPRINGCM-C-60-S21.2
NYLOCK HEX NUT1_2 - 1321.3
1/2" FLAT WASHER1/2" WASHER
41.4
WASHER3/8"
22
HEX HEAD FLANGE SCREW#10-24 x 1.25 HHFS
13
NYLOCK HEX NUT#10-24 NYLOCK HEX NUT
14
FLAT HEAD C'SUNK CAP SCREW#10-32 x 3/43
5
TURNOVER BALL COMPLETECM-C-60-B16
CAST LOCK PINCM-C-600-CLP1
7
.375" HANDLE RODCM-C60-R18
7.5 LB COMPRESSION SPRINGCM-C-60-CS19
VINYL HANDLE GRIPCM-C-60-H
110
RUBBER COVERCM-C-60-C
111
.300" U-SHAPED EDGINGCM-UE1
112
3.75 DIA. x .375" CHROME RINGCM-C-600-CR
113
TOP VIEW OF HITCH
BOTTOM VIEW OF HITCH
HIGH RIB SECTION
LOW RIB SECTIONS
HOLE LOCATION
FOR SAFETY CHAIN
ATTACHMENTS
OPTIONAL
WHEN BALL IS NOT IN USE,
REMOVE BALL AND INSERT
SUPPLIED RUBBER COVER
12/18/2007
PAGE 1
USE C-625 CENTER SECTION TO
LOCATE AND DRILL SAFETY
CHAIN ATTACHMENT HOLES
11
6
5
13
12
1.1
8
10
1.2
1.4
1.3
3
4
7
9
2
WARNING DO NOT invert ball when carrying heavy loads on 2 wheeldrive trucks. The ball may hit the
differential, brake lines, or sensors. (NOTE: Do not invert ball on any Toyota Tundra models)