Owners manual

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
C-620 NISSAN TITAN GOOSENECK HITCH
FIGURE 1
Parts List
DESCRIPTIONPART NUMBERQTYITEM
SAFETY CHAIN LOOP ASSEMBLYCM-C-60-CLA
21
2" x 3" SAFETY CHAIN LOOPCM-C-60-CL
11.1
5 LB U-BOLT SPRINGCM-C-60-S
21.2
NYLOCK HEX NUT
1_2 - 1321.3
1/2" FLAT WASHER1/2" WASHER41.4
WASHER3/8"22
HEX HEAD FLANGE SCREW#10-24 x 1.25 HHFS13
NYLOCK HEX NUT#10-24 NYLOCK HEX NUT14
FLAT HEAD C'SUNK CAP SCREW#10-32 x 3/43
5
TURNOVER BALL COMPLETECM-C-60-B
16
CAST LOCK PINCM-C-600-CLP
17
.375" HANDLE RODCM-C60-R
18
7.5 LB COMPRESSION SPRINGCM-C-60-CS
19
VINYL HANDLE GRIPCM-C-60-H110
RUBBER COVERCM-C-60-RC111
.300" U-SHAPED EDGINGCM-UE1112
3.75 DIA. x .375" CHROME RINGCM-C-600-CR113
TOP VIEW OF HITCH
BOTTOM VIEW OF HITCH
USE C-620 CENTER SECTION TO
LOCATE AND DRILL SAFETY
CHAIN ATTACHMENT HOLES
HIGH RIB SECTION
LOW RIB SECTIONS
HOLE LOCATION
FOR SAFETY CHAIN
ATTACHMENTS
OPTIONAL
WHEN BALL IS NOT IN USE,
REMOVE BALL AND INSERT
SUPPLIED RUBBER COVER
PAGE 1
11
2
1.1
12/18/2007
6
5
13
8
10
9
4
3
7
1.2
1.4
1.3
12
WARNING DO NOT invert ball when carrying heavy loads on 2 wheel drive trucks. The ball may hit the
top of the differential, brake lines, or sensors. (NOTE: Do not invert ball on any Toyota Tundra models)