Owners manual

INSTALLED HITCH
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
30,000 7,500
52
45
RAM 2500
1/16/2014
60614
90
WARNING!! BRAKE, FUEL, AND ELECTRICAL LINES MAY NEED TO BE LOOSENED OR REPOSITIONED TO PROVIDE CLEARANCE
FOR NEW HARDWARE. SOME MODELS REQUIRE MODIFICATION OR REMOVAL OF HEAT SHIELDS. ON SHORT BED MODELS,
CHECK FOR ADEQUATE TURNING CLEARANCE BETWEEN THE FRONT OF ALL TRAILERS AND THE TRUCK CAB.
- LOWER SPARE TIRE
- LOWER EXHAUST
- NO MEASURING DRILL LOCATIONS
- NO DRILLING INTO FRAME
PAGE 1 OF 4
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Scan
for more
information
Hardware List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX FB ZINC w/NYLON PATCH5/8-11 x 1-1/2"
4
1
CENTER LOCK NUT5/8-18
42
5/8" SQUARE U-BOLT
60614-UB23
U-BOLT SPRINGCM-C113-UBS
44
FLAT WASHERM16 WASHER
85
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
GOOSENECK CENTER SECTION60614-WA1
A
NUT PLATE WELDMENT60614-NPW2B
RUBBER COVER
661551
C
OE GOOSEBALL
606011D
←
R
E
A
R
R
E
A
R
→
TOOLS REQUIRED
TORQUE WRENCH
RATCHET
15/16" SOCKET
EXTENSION
DRILL
3-1/4" HOLE SAW
1/4" & 11/16" DRILL BIT
PRY BAR
CUTTING FLUID
RUST INHIBITOR
EAR PROTECTION
SAFETY GLASSES
TRUCK BED
FACTORY CROSS
MEMBER
REAR BED SUPPORT
PASSENGER SIDE
FRAME RAIL
FRONT BED SUPPORT
DRIVER SIDE
FRAME RAIL
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
FRONT BED SUPPORT
REAR BED
SUPPORT
TRUCK BED
(TRIMMED FOR CLARITY)
NOTE
: INSERT SUPPLIED RUBBER
COVER WHEN NOT IN USE
NOTE
: REVIEW 60601
INSTRUCTION SHEET
PRIOR TO USE
FACTORY CROSS
MEMBER
NOTE: REQUIRES DRILLING
THROUGH THE FACTORY
CROSSMEMBER (4) PLACES
FOR SAFETY CHAIN LOOPS
1
2
4
5
B
C
D
A
3
B