Installation Guide

ManualsBrandsCURT ManualsAutomotiveDouble Lock 2-5/16" Offset Gooseneck Ball (4" Rearward Offset)

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

HITCH WEIGHT: LBS.

INSTALL TIME: MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

20,000 5,000

DOUBLE LOCK GOOSENECK EXTENDER

12/29/08

C-602

Application:

The Double Lock Gooseneck Extender is not to be used with plastic bed liners or other additions to the bed

floor, which prohibits the gooseneck extender from being fully seated inside the Double Lock cylinder, or

being engaged by the Double Lock pins. Make sure that the Extender you purchased fully seats in the

gooseneck, and can be fully locked by the pins of your gooseneck hitch. Please review tow rating

information, and turning clearance warning.

Installation:

Disengage the double lock pins and remove ball or any other accessory. Place the round shank of the

extender into the Double Lock cylinder, so that the ball is closer to the rear of the pickup

than the round

shank. Engage the Double Lock pins. Make sure that the pins fully engage the round shank of the extender

and pass through the cylinder completely. For hitch accessories that remain in the Double lock Gooseneck

for an extended period of time, Curt Mfg. recommends lightly lubricating the round shank with grease.

- NO DRILLING OR CUTTING REQUIRED

- WILL NOT FIT WITH BED LINERS

ROUND SHANK

(GREASE REGULARLY)

BALL

(GREASE WITH EACH

USE TO REDUCE WEAR)

PINS

(MUST ENGAGE FULLY)

FACES REAR

OF VEHICLE

** CAN NOT BE USED WITH PLASTIC BED LINER **