Installation Guide

58968-INS-RA
•
PAGE 5
Step 12
Route the 4-flat wire along the
driver-side inner fender. Zip tie as
needed to the front of the vehicle.
Step 13
Route between the headlight and the
windshield washer fluid tank. Mount
the 4-flat right next to the vehicle
ground lug on the driver side.
Step 14
Secure any excess wire so that it is not drooping or dangling, but not so tight that
it causes unnecessary strain to the wire which could lead to breakage over time.
After removing slack from the 4-flat wire, tighten any zip ties and add as needed.
Use a zip tie to fasten any excess wire to a solid spot along the driver-side inner fender.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.