Installation Guide

58968-INS-RA
•
PAGE 3
Step 4 - How to use fish wire
A) Fish wire is a way to push or pull
an electrical wire through a blind hole.
Make sure the wire is long enough
to stick out on the other side.
Insert the fish wire through the blind
hole and locate it on the other side.
B) Use tape to secure the harness
to the fish wire and pull back up.
The fish wire or harness may get hung up on
something, if this happens you may have to
push back down, wiggle it around or twist the
wire to loosen it from what it’s hung up on.
Fish wire could be anything from a cut-up
wire hanger, stiff wire, rope or string depending
on what is needed for the installation.
Step 5
Starting on the driver side, run a fish wire
down between the body and the bumper cover.
From under the vehicle, locate the end of
the custom RV harness with the yellow wire.
Attach the yellow side to the fish wire and
pull the harness up to the factory harness.
Insert the custom RV harness into the factory
wiring. Make sure the connectors are fully
inserted with the locking tabs in place.
Reinstall the taillight back into its housing.
Step 6
From under the vehicle, route the harness
end with the green wire along the back
side of the bumper. Zip tie in place,
making sure the wires will not come
into contact with moving or hot objects.
Repeat steps 5 and 6 with the green wire
on the passenger side of the vehicle.
A
B
A
B