Installation Guide

WIRING INSTALLATION
A B C
Step 1
Locate vehicle taillight wiring. Refer to the
wiring location guide on the second page.
Step 2
Identify the wiring type of your vehicle using the 'How to
Determine Vehicle Wiring Types' instructions on page two.
Step 3
Locate vehicle battery and disconnect
the negative battery terminal.
Step 4
Using snap locks, attach the input wires of the taillight converter
to the corresponding vehicle harness wires identified in Step 2
using the 'Wiring Installation' table below. Refer to photos A, B
and C to install the snap locks.
Step 5
Locate a flat spot near the taillight. Adhere the black converter
box using the provided double-sided tape and secure it with the
included cable ties.
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the
ring terminal and provided screw.
WARNING: Check for miscellaneous items that
may be hidden behind or under any surface before drilling
to avoid damage and / or personal injury.
Step 7
Secure any loose wires with the provided cable ties. Reinstall
all items removed during install and reconnect negative battery
terminal. When in use, route the 4-flat to the center of the vehicle.
When not in use secure in a convenient out of the way location.
INSTALLATION
* Butt connector
* Butt connector
* 12 GA wire or larger
Red -
Brake
If using the converter
as a powered module
for a two-wire system,
the red brake wire
must be grounded
This converter system is only to be used
on 12 volt negative ground systems
Route 12 GA wire to vehicle battery
location, taking care to avoid any pinch
points and hot or rotating components.
ATTENTION!
Not Included:
* 12 gauge wire
* 10 amp fuse max
* Yellow fuse holder
* Butt connectors
* Ring terminal
Items can be purchased as a kit,
CURT part# 55151, sold separately
Brown -
Taillight
Yellow -
Lef t Turn
Green - Right turn
* Use ring terminal
for battery connection
* Fuse holder with 10 amp
fuse max (install fuse after
all other steps are complete)
Attach the ring terminal of the
white ground wire to vehicle
body using the screw provided
(drill 3/32" hole if necessary)
Mount converter using the
double-sided tape provided
Route black wire to
positive battery (+)
Vehicle battery
Disconnect negative battery
(-)
cable before wiring the power wire
12-1012-10
Converter
CONVERTER WIRING DIAGRAM
Vehicle Wiring Type Green Wire Red Wire Yellow Wire Brown Wire
Two-wire Splice to right stop / turn wire Ground with white wire Splice to left stop / turn wire Splice to tail wire
Three-wire Splice to right turn wire Splice to stop wire Splice to left turn wire Splice to tail wire
PAGE 3 • 56496-INS-RB