Installation Guide

56426-INS-RA
•
PAGE 3
Step 6
Route the custom wiring end with
the green wire to the passenger side
along the backside of the bumper.
Repeat step 4 on the passenger side using the
wiring end with the green wire. Secure any
loose wires with the provided cable ties.
Step 5
Locate a flat clean surface that is out of the path of spray and debris from the rear wheels and
road. Adhere the black converter box using the provided double-sided tape. Failure to mount the
box in a protected area can cause loss of warranty, product failure, overheating and potential fire.
Locate a grounding point near the box such as an existing screw or bolt in the frame
of the vehicle or drill a 3/32"pilot hole. The area should be free from rust, dirt, and paint
(abrasive pad/paper to remove rust and paint). Secure the white ground wire with the
ring terminal on the existing fastener or with the provided ground screw.
CAUTIO N
Check for miscellaneous items that may be hidden behind or under
any surface before drilling to avoid damage and/or personal injury
Step 7
Insert the harness into the factory wiring and connect the taillight.
Make sure the connectors are fully inserted with locking tabs in place.
Step 8
Route the black power wire from the vehicle battery as shown on the last page of this manual.
NOTICE
Once the 12 volt power wire is connected to the harness verify that the harness is functioning
by attaching the battery and testing with a test light, 4-flat tester, or a functioning trailer.
When in use, route the 4-flat to the center of the vehicle and out of the trunk.
When not in use, roll up and store in a convenient, out of the way location
inside the trunk. Secure any loose wires with the provided cable ties.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.