Installation Guide

H
Step 6
Locate the grommet behind the taillight where the vehicle
taillight wiring passes though from inside the cabin to the
taillight (H). Remove the grommet and cut a slit large
enough to route the custom wiring harness though (I).
Step 7
Route the custom wiring harness end with the yellow wire
out through the grommet opening and though the slit in the
grommet. Insert the custom wiring harness end with the
yellow wire between the separated connectors. Make sure the
connectors are fully inserted with locking tabs in place.
Step 8
Reseat the grommet and use the provided sealant
to seal the cut in the grommet and around all the wires.
Step 9
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 10
Route the custom wiring harness end with the green wire
down behind the interior side panel and out to the passenger
side behind the removed scuff panel. Repeat steps 3-8 on the
passenger side using the harness end with the green wire.
Step 11
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 12
Route the black power wire from the vehicle’s battery
as shown on the included CME-PCL-INS sheet.
Step 14
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 15
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
1 2
O
3 4
O OO
1 2
I
3 4
I II
PAGE 3 • 56400-INS-RA