Installation Guide

A B C

E F

Step 1

Open the vehicle trunk. Remove all trunk floor coverings (A).

Step 2

Remove the fasteners securing the rear scuff panel. Remove

the scuff panel by pulling out on the bottom and then up. Take

care not to damage the alignment tabs on the back (B).

Step 3

Starting on the driver side of the trunk, remove the push

fasteners from the side felt panel (C). Pull out on the trunk liner

so that the taillight mounting fasteners are exposed (D).

Step 4

On the outside of the vehicle on the driver side, locate the taillight.

Remove the two nuts that hold the taillight assembly in place (E).

Remove the taillight by gently pulling rearward, taking care not to

damage the alignment tabs on the back of the taillight (F).

Step 5

Behind the removed taillight, locate the vehicle taillight wiring

harness connectors. The connectors will be similar to those on

the custom wiring harness. Separate the connectors taking care

not to damage the locking tabs (G). Set taillight aside for later

installation.

INSTALLATION

SAFETY INSTRUCTIONS

56400-INS-RA • PAGE 2