Installation Guide

A B

G I

E F

Step 1

Open the rear hatch. Remove all floor coverings,

the spare tire and storage trays (A,B,C).

Step 2

Remove the two cargo tie downs securing the rear scuff panel.

Remove the scuff panel by pulling straight up. Take care not to

damage the alignment tabs on the back (D,E).

Step 3

Using the panel trim removal tool,

open the driver side trim panel (F).

Step 4

Locate the driver side taillight. Begin removal of the taillight by

removing the plastic taillight trim cover (G). Locate and remove

the two fasteners securing the taillight in place (H). Gently pull

rearward to remove the taillight. Take care not to damage the

alignment tabs on the back (I).

Step 5

Locate the vehicle taillight wiring harness connectors on the

backside of the taillight. The connectors will be similar to those

on the custom wiring harness. Separate the connectors from the

taillight housing taking care not to damage the locking tabs (J).

Set taillight aside for later installation.

Step 6

Locate the grommet behind the taillight where the vehicle

taillight wiring passes though from inside the cabin to the

taillight (K,L). Remove the grommet and cut a slit large enough

to route the custom wiring harness though (M1, M2).

Step 7

Route the custom wiring harness end with the yellow wire

out through the grommet opening and though the slit in the

grommet (M3, M4). Insert the custom wiring harness end with

yellow wire between the separated connectors. Make sure the

connectors are fully inserted with locking tabs in place.

Step 8

Reseat the grommet. Use the provided cable tie to secure the

wires passing through the grommet together. Use the provided

sealant to seal the cut in the grommet and around all the wires.

Reinstall the driver side taillight.

INSTALLATION

SAFETY INSTRUCTIONS

56384-INS-RA • PAGE 2