Installation Guide

Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle tailgate to access the taillight assemblies.
Step 3
Remove the two T-30 Torx screws securing the taillight
assemblies. Gently pull out on the taillight making sure not
to damage the alignment tabs on back (A).
Step 4
Starting on the driver side locate the vehicle taillight wiring
harness connectors (B). The connectors will be similar to those
on the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs (C).
Step 5
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place.
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 7
Locate a flat clean surface that is out of the path of spray
and debris from the rear wheels and road. Adhere the black
converter box using the provided double-sided tape. Failure to
mount the box in a protected area can cause loss of warranty,
product failure, overheating and potential fire.
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
Route the custom wiring harness end with the green wire under
the vehicle and up through the opening under the taillight using
fishwire (D). Route the wire to the passenger side along the
backside of the bumper and up through the opening under the
passenger side taillight. Repeat steps 3-5 on the passenger side
using the harness end with the green wire.
Step 10
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 11
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
A B C
D
56331-INS-RB • PAGE 2