Installation Guide

A B
H
C
D
G I
E F
Step 1
Open the vehicle tailgate. Remove the two 10mm bolts securing
the taillight. Carefully pull the taillight rearward taking care not
to damage the locking tabs (A,B).
Step 2
Behind the removed taillight locate the vehicle taillight wiring
harness connectors (C). The connectors will be similar to those
on the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs.
Step 3
Locate the grommet behind the taillight where the vehicle
taillight wiring passes though from inside the cabin to the
taillight. Remove the grommet and cut a slit large enough
to route the custom wiring harness though (D).
Step 4
Remove all floor mats and spare tire compartment cover (E,F).
Remove the rear scuff panel (G) and the plastic storage trays
surrounding the spare tire (H).
Step 5
On the driver side, route the custom wiring harness end with
yellow wire under the rear trim panel and out through the
grommet opening and though the slit in the grommet (I). Insert
the custom wiring harness end with yellow wire between the
separated connectors. Make sure the connectors are fully
inserted with locking tabs in place.
Step 6
Reseat the grommet using the provided sealant
to seal the cut in the grommet and around all the wires.
Step 7
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 8
Route the wiring harness end with the green wire to the passenger
side behind the removed scuff panels. Repeat steps 3-5 on the
passenger side using the harness end with the green wire.
Step 9
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 10
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 11
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 12
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56121-INS-RA • PAGE 2