Installation Guide

1. Open the rear hatch. Remove both taillight
housings by removing screws on each using a
8mm socket. Pull out on the housing to locate
the vehicles taillight wiring harness. The
harness will have connectors similar to those on
the T-connector harness.
2. Starting on the drivers side separate the
connectors being sure not to damage the
locking tabs. Insert the T-connector end with
the yellow wire in-between the separated
connectors. Make sure the connectors are fully
inserted with locking tabs in place.
3. Route the T-connector end with the green
wire and the 4-flat down through the opening
under the taillight. Under the vehicle route
the green wire across the backside of the
bumper to the passenger side and up through
the opening under the passenger side taillight.
Repeat step 2 on the passenger side using the
green wire.
4. Locate a suitable grounding point near the
connector such as an existing screw with nut in
the vehicle’s frame or drill a 3/32” hole and
secure white wire using eyelet and screw
provided.
5. Adhere the black converter box to the frame
of the car using the double-sided tape provided.
6. Route the black power wire from the battery
as shown on the CME-PCL-INS sheet included.
7. Route the 4-flat to the center of the vehicle
and secure in a convenient out of the way
location. Secure any loose wires with the cable
ties provided.
WARNING!
Verify miscellaneous items that may be hidden
behind or under any surface before drilling to
avoid damage and/or personal injury.
10/5/09
56095
LINCOLN MKT