Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Panel trim removal tool

Make Model

Chevrolet Equinox

Pontiac Torrent

Suzuki X L-7

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S3 - Behind driver side rear access panel

S4 - Behind passenger side rear access panel

S3 S4

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

PAGE 1 • 56012-INS-RC

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Make Model Chevrolet Equinox Representative vehicle shown below Pontiac Torrent S3 - Behind driver side rear access panel Suzuki XL-7 S4 - Behind passenger side rear access panel CUSTOM WIRING CONNECTOR S3 S4 NOTICE All steps must be followed to ensure the wiring connector will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate vehicle battery on the driver side under the hood and disconnect the negative battery terminal. Step 2 Chevrolet Equinox / Pontiac Torrent Open the vehicle tailgate. On the driver side, locate the vehicle jack storage compartment and remove the panel and jack (A). Suzuki XL-7 Open the vehicle tailgate. On the passenger side, locate the vehicle jack storage compartment and remove the panel and jack.